If the ((p)) light of the vehicle is on normally, it means that the electronic parking system is turned on, the owner turns off the electronic handbrake, and the indicator light It will be extinguished, and the car owner doesn't need to worry too much. However, when starting the vehicle, do not pull up the electronic handbrake, which will cause a certain degree of damage to the vehicle.
p The solution to the yellow light: The yellow p on the dashboard of the car represents the working state of the parking brake. If the handbrake is not in place in the brake position, the parking brake must be applied first and then the gear lever must be moved to the "P" (parking) position.
When preparing to start the car, the shift lever should be replaced from the "P" (parking) gear before releaseing the parking brake.
It may be debris entering the brake system, ((p)) The yellow light will turn on, and the owner needs to remove the debris in time. It may be that the brake pads and brake discs of the vehicle are seriously worn, and the system will prompt that the owner needs to replace the brake pads and brake discs of the vehicle in time.
1. Parking brake indication. GB4094 Automobile Control Parts, Indicator Signal Device" stipulates that (P) is red when lit, indicating that the parking brake (handcuff) is working. The car dashboard is a device that reflects the working status of various systems of the vehicle.
2. P on the gear. Some models are equipped with P gear, and the dashboard will display P.P gear, the abbreviation of parking in English, parking gear. Most of them are used when the engine is turned off and parked. A lot of cars need to be hung in P gear, which can cut off the power, pull out the key, and lock the door. After hanging into P gear, the braking device of the car will be locked.
3. Some cars are in P gear, and the dashboard will display P.P gear, the abbreviation of English parking, parking gear. Most of them are used when the engine is turned off and the car is stopped. Many vehicles need to be in P gear to cut off the power supply, pull out the key and lock the door. After entering P gear, the braking device of the vehicle will be locked.
4. When the dashboard shows p, it means that the parking brake is working. Parking brake, usually refers to the manual brake installed in motor vehicles, referred to as handbrake, is used to stabilize the vehicle after the vehicle is stable to avoid accidents caused by slipping when the vehicle is parked on the slope.
Parking brake indication. GB4094 Automobile Control Parts, Indicator Signal Device" stipulates that (P) is red when lit, indicating that the parking brake (handcuff) is working. The car dashboard is a device that reflects the working status of various systems of the vehicle.
The dashboard of the motor vehicle displays the P handbrake indicator light. When the indicator light is on, it means that the electronic parking brake is on. There are generally two situations where this light is on: one is that the handbrake is not put to the end; the second is the brake system failure warning.
P on the gear in the vehicle means parking gear. It is the most common gear in automatic gear models; usually in the front position of the gear workbench, in front of the R gear;It is mainly used when you park the car and don't use it. The gear is here. At this time, the wheel is in mechanical dead mode, which can avoid slipping.
1. The P button on the car is the key to turn on the reversing radar. The on-board reversing radar is set to on mode by default. If the driver thinks that the reversing radar prompt is not needed, he can press this button to turn off the reversing radar function. The full name of the reversing radar is the reversing anti-collision radar, also known as the reversing auxiliary device.
2. The ((p)) button of the car refers to the electronic parking brake of the car, which is simply the handbrake of the car.
3. Parking brake indication. GB4094 Car control parts, instructionsThe instrument signal device stipulates that (P) is red when it is lit, indicating that the parking brake (handwheel) is working. The car dashboard is a device that reflects the working status of various systems of the vehicle.
4. p means parking gear, which is the most common gear in automatic transmission models. It is usually located in the front of the gear console, in front of the R gear. It is mainly used when you don't park the car, and the gear is here. At this time, the wheel is in a mechanical locking state, which can prevent slipping. Main uses: flat parking, ramp parking and idle ignition.
5. The on-board ((p)) button refers to the parking brake. When the parking indicator light on the car lights up, it means that the parking brake of the car is working and the color of the parking brake is red. The parking brake is just the handbrake of the car. The function of the handbrake is to give the car a resistance when parking, and the brake to prevent the car from slipping.
P on the gear in the vehicle means parking gear. It is the most common gear position in automatic gear models; usually in the front position of the gear workbench, in front of the R gear; it is mainly used when you stop and do not use it, and the gear position is here. At this time, the wheel is in mechanical dead mode, which can avoid slipping.
The dashboard shows P. The sign is: a circle, a P in the middle, () on both sides of the circle, and the whole logo is red, indicating the parking brake indicator, which is used to indicate whether the parking brake (handbrake) is working. When the parking brake (handbrake) is pulled up, the indicator light is on, and when the handbrake is released, the indicator light goes out.
The P button on the car is the key to turn on the reversing radar.The reversing radar of the car is turned on by default. If the driver thinks that the reversing radar prompt is not necessary to avoid boredom, he can press this button to turn off the reversing radar function. The full name of the reversing radar is "reversing anti-collision radar", also known as "parking auxiliary device".
The button with the letter p on the car is the electronic handbrake button. If this button is on the gearshift lever, it represents the p gear. All automatic transmission cars have p gear, and p gear is the parking gear, which is used when parking and turning off the engine. After hanging into p gear, the car can stop differently.
Global trade analysis dashboard-APP, download it now, new users will receive a novice gift pack.
If the ((p)) light of the vehicle is on normally, it means that the electronic parking system is turned on, the owner turns off the electronic handbrake, and the indicator light It will be extinguished, and the car owner doesn't need to worry too much. However, when starting the vehicle, do not pull up the electronic handbrake, which will cause a certain degree of damage to the vehicle.
p The solution to the yellow light: The yellow p on the dashboard of the car represents the working state of the parking brake. If the handbrake is not in place in the brake position, the parking brake must be applied first and then the gear lever must be moved to the "P" (parking) position.
When preparing to start the car, the shift lever should be replaced from the "P" (parking) gear before releaseing the parking brake.
It may be debris entering the brake system, ((p)) The yellow light will turn on, and the owner needs to remove the debris in time. It may be that the brake pads and brake discs of the vehicle are seriously worn, and the system will prompt that the owner needs to replace the brake pads and brake discs of the vehicle in time.
1. Parking brake indication. GB4094 Automobile Control Parts, Indicator Signal Device" stipulates that (P) is red when lit, indicating that the parking brake (handcuff) is working. The car dashboard is a device that reflects the working status of various systems of the vehicle.
2. P on the gear. Some models are equipped with P gear, and the dashboard will display P.P gear, the abbreviation of parking in English, parking gear. Most of them are used when the engine is turned off and parked. A lot of cars need to be hung in P gear, which can cut off the power, pull out the key, and lock the door. After hanging into P gear, the braking device of the car will be locked.
3. Some cars are in P gear, and the dashboard will display P.P gear, the abbreviation of English parking, parking gear. Most of them are used when the engine is turned off and the car is stopped. Many vehicles need to be in P gear to cut off the power supply, pull out the key and lock the door. After entering P gear, the braking device of the vehicle will be locked.
4. When the dashboard shows p, it means that the parking brake is working. Parking brake, usually refers to the manual brake installed in motor vehicles, referred to as handbrake, is used to stabilize the vehicle after the vehicle is stable to avoid accidents caused by slipping when the vehicle is parked on the slope.
Parking brake indication. GB4094 Automobile Control Parts, Indicator Signal Device" stipulates that (P) is red when lit, indicating that the parking brake (handcuff) is working. The car dashboard is a device that reflects the working status of various systems of the vehicle.
The dashboard of the motor vehicle displays the P handbrake indicator light. When the indicator light is on, it means that the electronic parking brake is on. There are generally two situations where this light is on: one is that the handbrake is not put to the end; the second is the brake system failure warning.
P on the gear in the vehicle means parking gear. It is the most common gear in automatic gear models; usually in the front position of the gear workbench, in front of the R gear;It is mainly used when you park the car and don't use it. The gear is here. At this time, the wheel is in mechanical dead mode, which can avoid slipping.
1. The P button on the car is the key to turn on the reversing radar. The on-board reversing radar is set to on mode by default. If the driver thinks that the reversing radar prompt is not needed, he can press this button to turn off the reversing radar function. The full name of the reversing radar is the reversing anti-collision radar, also known as the reversing auxiliary device.
2. The ((p)) button of the car refers to the electronic parking brake of the car, which is simply the handbrake of the car.
3. Parking brake indication. GB4094 Car control parts, instructionsThe instrument signal device stipulates that (P) is red when it is lit, indicating that the parking brake (handwheel) is working. The car dashboard is a device that reflects the working status of various systems of the vehicle.
4. p means parking gear, which is the most common gear in automatic transmission models. It is usually located in the front of the gear console, in front of the R gear. It is mainly used when you don't park the car, and the gear is here. At this time, the wheel is in a mechanical locking state, which can prevent slipping. Main uses: flat parking, ramp parking and idle ignition.
5. The on-board ((p)) button refers to the parking brake. When the parking indicator light on the car lights up, it means that the parking brake of the car is working and the color of the parking brake is red. The parking brake is just the handbrake of the car. The function of the handbrake is to give the car a resistance when parking, and the brake to prevent the car from slipping.
P on the gear in the vehicle means parking gear. It is the most common gear position in automatic gear models; usually in the front position of the gear workbench, in front of the R gear; it is mainly used when you stop and do not use it, and the gear position is here. At this time, the wheel is in mechanical dead mode, which can avoid slipping.
The dashboard shows P. The sign is: a circle, a P in the middle, () on both sides of the circle, and the whole logo is red, indicating the parking brake indicator, which is used to indicate whether the parking brake (handbrake) is working. When the parking brake (handbrake) is pulled up, the indicator light is on, and when the handbrake is released, the indicator light goes out.
The P button on the car is the key to turn on the reversing radar.The reversing radar of the car is turned on by default. If the driver thinks that the reversing radar prompt is not necessary to avoid boredom, he can press this button to turn off the reversing radar function. The full name of the reversing radar is "reversing anti-collision radar", also known as "parking auxiliary device".
The button with the letter p on the car is the electronic handbrake button. If this button is on the gearshift lever, it represents the p gear. All automatic transmission cars have p gear, and p gear is the parking gear, which is used when parking and turning off the engine. After hanging into p gear, the car can stop differently.
Trade data for intellectual property checks
author: 2024-12-23 22:53How to analyze customs transaction records
author: 2024-12-23 21:59How to find untapped export partners
author: 2024-12-23 21:19How to identify emerging market suppliers
author: 2024-12-23 20:34Supplier compliance audit automation
author: 2024-12-23 20:33Canada shipment tracking services
author: 2024-12-23 22:04Industry-specific trade tariff analysis
author: 2024-12-23 21:53Trade data integration with ERP systems
author: 2024-12-23 20:59How to enhance supplier collaboration
author: 2024-12-23 20:59Identifying growth markets via HS code data
author: 2024-12-23 20:24979.81MB
Check583.42MB
Check264.53MB
Check242.62MB
Check231.26MB
Check931.92MB
Check255.79MB
Check199.96MB
Check168.33MB
Check624.57MB
Check968.59MB
Check167.49MB
Check693.71MB
Check683.46MB
Check861.66MB
Check984.16MB
Check658.33MB
Check478.47MB
Check618.11MB
Check435.66MB
Check449.19MB
Check783.42MB
Check521.75MB
Check985.65MB
Check198.94MB
Check245.85MB
Check945.78MB
Check653.25MB
Check931.75MB
Check614.61MB
Check296.98MB
Check497.49MB
Check794.74MB
Check283.87MB
Check229.27MB
Check983.47MB
CheckScan to install
Global trade analysis dashboard to discover more
Netizen comments More
1233 Refined sugar HS code identification
2024-12-23 22:29 recommend
2317 How to enhance supplier collaboration
2024-12-23 22:05 recommend
85 Global import export data subscription
2024-12-23 21:55 recommend
2711 High-value machinery HS code classification
2024-12-23 20:46 recommend
826 Low-cost trade data platforms
2024-12-23 20:33 recommend