1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
Canada HS code classification assistance-APP, download it now, new users will receive a novice gift pack.
1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
HS code compliance for customs
author: 2024-12-24 01:18Real-time container throughput data
author: 2024-12-24 00:38Global sourcing risk by HS code
author: 2024-12-23 23:45Long-tail trade keyword research
author: 2024-12-24 01:37How to improve trade compliance
author: 2024-12-24 00:56HS code-based competitive advantage analysis
author: 2024-12-24 00:11HS code-based reclassification services
author: 2024-12-23 23:54How to ensure transparency in supply chains
author: 2024-12-23 23:53916.91MB
Check166.87MB
Check343.93MB
Check474.55MB
Check921.76MB
Check211.17MB
Check212.15MB
Check514.98MB
Check388.85MB
Check158.29MB
Check622.22MB
Check814.11MB
Check568.41MB
Check194.77MB
Check143.25MB
Check145.37MB
Check155.32MB
Check649.42MB
Check238.12MB
Check797.47MB
Check437.46MB
Check753.59MB
Check142.27MB
Check748.64MB
Check513.77MB
Check297.49MB
Check247.33MB
Check784.66MB
Check963.42MB
Check717.67MB
Check273.12MB
Check233.58MB
Check446.93MB
Check551.55MB
Check222.79MB
Check134.83MB
CheckScan to install
Canada HS code classification assistance to discover more
Netizen comments More
2381 Global trade compliance best practices
2024-12-24 01:38 recommend
208 Data-driven trade procurement cycles
2024-12-24 00:20 recommend
439 HS code alignment with sustainability targets
2024-12-24 00:17 recommend
2671 Special economic zones HS code strategies
2024-12-23 23:45 recommend
2053 HS code classification tools
2024-12-23 23:20 recommend