HS code-based data mining for analytics

List of contents of this article:

• 1,HS code-based data mining for analytics How to look at the oil scale
• 2、How to look at the car engine oil diper

How to look at the oil diper

Open the engine cover and HS code-based data mining for analyticsfind the oil diper next to the engine. Pull out the oil diaper and wipe it clean with a paper towel or towel. At this time, you can clearly see the two marks of the oil ruler. The bottom mark is the minimum limit of the oil, and the upper mark is the upper limit of the oil. After wiping clean, insert the oil ruler back.

How to look at the oil diper? Usually, when we look at the oil diper, we need to pull out the oil diper first, then wipe off the residual oil on the ruler with a rag, and then insert it into the oil pan.

The oil ruler will have two scale marks, the MAX upper limit and the MIN lower limit. Check the oil liquid level. If it is in the middle part, it means that it is in the normal position. Find the handle of the oil ruler in the engine compartment, pull out the oil ruler, and use a paper towel to wipe the oil stuck to the oil ruler as clean as possible. Plug it back in place, pay attention to insert the whole oil ruler to the end, and then pull it out.

When looking at the engine oil diper, pull out the oil diper first and wipe off the oil stuck to the head of the oil diper with a paper towel. Then insert the wiped oil ruler back to the bottom, and then pull it out. Observe the position of the oil stuck on the oil gauge.

Generally, the fuel tank is near the engine. Find the oil scale on the fuel tank. As soon as the engine was turned off, within 5 minutes, the oil gauge was not accurate, because the oil had not completely flowed back to the oil sumper.

How to view the engine oil scale

The steps to check the oil scale are as follows: park the vehicle on the flat ground, and Keep the vehicle turned off for about 20-30 minutes. Open the engine cover and find the oil dipenser next to the engine.

The oil scale is located in the engine compartment battery.On the left, the cover of the fuel tank is connected to the oil gauge. You can check the oil gauge by unscrewing the cover of the fuel tank.

How to look at the oil diper? Usually, when we look at the oil diper, we need to pull out the oil diper first, then wipe off the residual oil on the ruler with a rag, and then insert it into the oil pan.

Find the position of the oil ruler. The oil ruler is generally next to the engine, some on it, and some on the side. The ruler has an obvious feature, that is, there is a hand pull ring, so it is easy to identify.

According to the picture of the poster, the liquid level of this engine oil is still within the grid, so it should be considered normal, but 7000km, I personally feel that it should be maintained in time. If you are satisfied, please adopt it.

How to read the illustration of the car oil scale?

According to the following diagram, it is accurate to look at the oil displayed by the oil role at the right time and place. Time The correct time is: after the engine is turned off, leave it for 15 minutes before checking the oil scale. If you often need to check it, you can check it before starting the vehicle in the morning. At this time, the oil surface height is also accurate.

First of all, we open the main driver's door and find the switch to open the hood of the car. Generally, on the inside of the main driver's side, as shown in the figure, and then go to the front of the hood to find the front opening switch.

Before checking the oil scale, you need to park the car in a relatively flat parking space and wait for about 10 minutes, which can basically ensure the level accuracy of the oil.

As shown in the pictureIndicates that the oil ruler will have two scale marks, the MAX upper limit and the MIN lower limit. If you check that the oil liquid level is in the middle part, it means that it is in a normal position. Prepare a tissue before checking, and then find the handle of the oil scale in the engine compartment.

About three-quarters of the oil added between the upper and lower lines of the oil scale is the best position, that is, it is better to be above the upper and lower limits of the oil scale. The following is the standard picture of the oil gauge measurement. The oil level needs to be within the upper and lower limits of the oil gauge.

Question 1: How to view the oil scale. There is a grid at the bottom of the oil diper. If there is no grid, it is two scale lines. In the cold condition, the oil can be in the middle. If it is less than the lowest scale, it means that the oil is too little, and if it exceeds the highest scale, it is too much.

How to look at the car oil scale

1. Generally speaking, the oil level is more than 3/4 between the upper and lower lines when cooling the car, and the oil level is more than 1/2 between the upper and lower lines when heating the car, the amount of oil is enough. How to look at the oil dicator? Usually, we need to pull out the oil dicator first, then wipe off the residual oil on the ruler with a rag, and then insert it into the oil pan.

2. As shown in the figure, the oil ruler will have two scale marks, the MAX upper limit and the MIN lower limit. Checking that the oil liquid level is in the middle part, it means that it is in the normal position. Prepare a tissue before checking, and then find the handle of the oil scale in the engine compartment.

3. According to the picture of the poster, the liquid level of this engine oil is still within the grid.Therefore, it should be normal to consider, but 7000km, I personally feel that it should be maintained in time. If you are satisfied, please adopt it.

4. Find the position of the oil scale. The oil ruler is generally next to the engine, some on it, and some on the side. The ruler has an obvious feature, that is, there is a hand pull ring, so it is easy to identify.

How to look at the car engine oil scale

How to look at the car engine oil scale? The steps to check the oil scale are as follows: park the vehicle on the flat ground and keep the vehicle extinguished for about 20-30 minutes. Open the engine cover and find the oil dipenser next to the engine.

Can you look at the oil diper on the car? What is the oil diper? The oil is in the operation of the engine.The indispensable factors, whether adding more or less engine oil, will affect our normal driving.

According to the picture of the poster, the liquid level of this engine oil is still within the grid, so it should be considered normal, but 7000km, I personally feel that it should be maintained in time. If you are satisfied, please adopt it.

The first step is to find the joystick of the oil scale in the engine compartment of the car, and then prepare a piece of toilet paper in advance. Then pull out the oil diger and use toilet paper to wipe the oil stuck to the head of the oil meter as neatly as possible. At this moment, let's take a look at which part of the oil scale is (generally there are 2 rulers with MIN and MAX).

The way to check the engine oil scale is to open the door next to the cab. Pull the hood switch on the left side of the driver's leg.Lift the engine hood up. Use the support rod to support the hood.

Find the position of the oil ruler. The oil ruler is generally next to the engine, some on it, and some on the side. The ruler has an obvious feature, that is, there is a hand pull ring, so it is easy to identify.