Global trade certification services

List of the catalog of this article:

• 1,Global trade certification services How to open the Honda Accord hood
• 2, How to open the hatch of Metway engine?
• 3. How to open the Honda Accord hood, Accord engine compartment diagram Solution
• 4, How to open the car hood correctly and how to close the car hood correctly?
• 5, How to open the Volkswagen Baolai hood, Baolai engine compartment diagram
• 6,< A href='# How to open the hood of the car? Can the hood be opened from the outside?' title='How to open the hood of a car? Can the hood be opened from the outside?'>How to open the hood of a car? Can the hood be opened from the outside?

How to open the Honda Accord hood

1. Before the Honda Accord engine cover is opened, it must be opened in the car, and then turn the bar in the middle of the engine compartment to open it for the second time. Open the engine hatch cover. If the engine cover latch lever is difficult to move, or the latch bar can be opened without zipper, the latch tissue should be cleaned and moistened.

2. Open the door on the driver's side of the Honda Accord. Pull the hood switch on the left side of the Honda Accord driver's leg. Lift the engine hood of the Honda Accord upwards. Pull the trunk switch of the Honda Accord door. Push up to open the trunk.

3. At the position of the driver's left foot, there are two wrenches that control the hood and the trunk respectively; the buttons of the trunk and the fuel tank are integrated. Lifting up is to open the trunk, and pressing down is to open the fuel tank cover.

4. Before the Honda Accord hood is opened, it needs to be unlocked in the car, and then the lever in the center of the engine compartment needs to be unlocked for the second time before the engine hatch can be opened. If the engine cover latch is difficult to move, or the engine cover can be opened without pulling the latch, the latch mechanism should be cleaned and lubricated. .

5. Open the door on the driver's side of the Honda Accord. Pull the hood switch on the left side of the Honda Accord driver's leg. Lift the engine hood of the Honda Accord upwards.

How to open the hatch cover of Metway?

1. In the engine compartment, share a kettle with the front wiper. In the engine compartment, a kettle is shared with the front wiper. When the front cover is opened, the glass water filling port has a unified logo. The position of the rear wiper plus glass water is the same as that of our front wiper plus glass water. They are connected by pipes.

2. Find the place where the pull wire is broken, and pull it down with a vise to open it.

3. This engine is matched with a 7-speed dual-clutch gearbox. The dual-clutch gearbox has fast gearshift speed and high transmission efficiency, which is very suitable for use with small-displement turbocharged engines. The front suspension of Metway adopts McPherson-type independent suspension, and the rear suspension adopts semi-longitudinal arm-type independent suspension.

How to open the Honda Accord hood, Accord engine compartment illustration

The illustration of the Accord front cover is as follows: Tools : Honda Accord. Open the door on the driver's side of the Honda Accord. Pull the hood switch on the left side of the Honda Accord driver's leg. Lift the engine hood of the Honda Accord upwards.

Before the Honda Accord hood is opened, it needs to be unlocked in the car, and then the lever in the center of the engine compartment needs to be unlocked for the second time to open the engine hatch. If the engine cover latch is difficult to move, or the engine cover can be opened without pulling the latch, the latch mechanism should be cleaned and lubricated.

In the position of the driver's left foot, there are two wrenches that control the hood and the trunk respectively; the buttons of the trunk and the fuel tank are integrated. Lifting up is to open the trunk, and pressing down is to open the fuel tank cover.

First, find the hood, which is located on the driver's side of the engine compartment. Second, find the four screw knees to be removed. Third, use a screwdriver to unscrew the screw knee. When all of them are removed, the hood can be successfully removed. Finally, slowly open the hood with a small handle to complete the whole opening process.

The Accord engine cover switch is in the cab, and the light switch is located below. You can open the engine cover by pulling the latch, and use the top pillar to hold the engine cover. The engine cover has the function of protecting the engine and the effect of soundproofing.

How to open the car hood correctly and how to close the car hood correctly?

The handle switch only needs to be pulled hard; just press the button switch. After the first step, the hood of the car will bounce up slightly, revealing a gap of 3-5 cm. At this time, the engine cover has not been fully opened, and there is a safety buckle under the middle of the engine cover.

Find the hood switch in the lower left corner of the cab, and the hood will make a sound when it is turned on.Remove the support rod, hold the cover with both hands and put it down slowly.

At this time, the hood has not been locked with the safety buckle, so we need to put our hands directly above the hood and press down a little harder, and the hood can be closed.

How to open the hood of the car: Pull the hood under the steering wheel to open the handle, and you will hear a "bang". Stand directly in front of the car, push the cover switch up, and slowly lift the cover with both hands. Remove the support rod and support the cover. Please make sure that the support rod is fixed.

To close the hood, first lower the hood support rod, and then hold the hood with both hands and slowly lower it to 20 cm away from the closing point and release your hand, and the hood will close automatically. It should be noted not to open or close the hood with one hand, otherwise the gap between the two sides of the hood and the closing point will be inconsistent.

How to open the hood of Volkswagen Baolai, illustration of Baolai engine compartment

1. How to open the Volkswagen Baolai hood; before opening the hood, make sure that the front windshield glass wiper arm is connected to On the front windshield glass. Open the driver's side door and pull the engine compartment to open the handle in the direction of the arrow in the figure. As shown in Figure A below, the hatch will bounce open slightly under the action of spring force.

2. First, enter the cab of FAW Volkswagen Baolai Automobile and find the front cover switch below, as shown in the figure. Next, pull up the front cover of FAW Volkswagen Baolai to turn on the switch, as shown in the figure.

3. The way to open the hood of Volkswagen Bora is as follows: InWhen you open the wrench of the hood in the cab, you will hear a "stuck" sound. Lift the hood (there is also a hook at this time, so the hood can only lift a slit), put your hand in and pull the hook, so that it can be opened.

4. The engine compartment of Volkswagen New Baolai is shown in the figure below: Baolai is a sedan version of the fourth generation of Golf, which began to be launched overseas in 1998. The improved 2001 model produced by FAW Volkswagen.

5. Volkswagen Polo engine hood (hood) lock the opening handle is in the space of the driver's side foot, and the handle can be pulled to open the engine cover. The engine compartment cover has the effect of sound insulation, dust insulation and protection of the engine. After opening the engine cover, use the support rod to hold the engine cover.

How to open the hood of a car? Can the hood be opened from the outside?

1. Pull the hood button to open it. There is a hood button under the steering wheel of the car. As long as the owner pulls it, the hood will usually loosen. Lift the hood, put your hand in, and pull a mechanical buckle to open the hood. Change the cone to open the hood.

2. The hood switch is in the car and needs to be turned on manually. The position of the switch is around the foot pedal. There is a switch button on the left side of the pedal. We can press the switch to open the outer hood. Put the hydraulic cylinder of the hood into the groove of the hood to support it.

3. The hood of the car cannot be opened from the outside, but only from the cab. There is a wrench in the lower left corner of the driver to open the hood.You can pull the wrench to open the hood. When you open the hood, you will hear the sound of the engine compartment. After opening the hood, the hood cannot be lifted automatically. There is a switch in the middle of the hood.

4. Open the hand. Open the hood of the car. You can sit in the driver's seat first. After finding the engine switch handle on the left side of the driver's seat, pull the car engine handle by hand. After hearing a bang, there will be an obvious gap in the hood of the car, and the hood can be pulled up at this time.