HS code-based KPI reporting for trade teams

List of contents of this article:

• 1,HS code-based KPI reporting for trade teams The correct operation of manual transmission car start
• 2, car start stepsSudden
• 3, The correct method of starting a manual transmission car

The correct operation of manual transmission car starting

1. Confirm the gear position and handbrake. Make sure that the gear is idle and the handbrake is in a pull-up state. Hang gear. Step on the clutch pedal and brake pedal, start the engine, put the gear in 1st gear, and then release the handbrake. Lift the clutch.

2. The correct way to start the manual transmission is as follows: step on the clutch pedal and hang the transmission lever into the first gear.Press the horn and relax the handbrake.

3. The correct step for manual gear start is 1 completely step on the clutch 2 hang up to 1 gear 3 turn on the left turn signal 4 press the horn to remind 5 release the handbrake 6 lift the clutch with the left foot 7 start the vehicle to start, the clutch of the left foot should be stable, no pressure or lift operation to avoid shutdown 8 steady.

4. The manual transmission start is to step on the clutch, the second to hang the gear, the third to turn, the fourth horn, the fifth to release the brake, release the clutch, and gently put oil to start. It should be noted that you must step on the clutch to the end, otherwise it will cause great damage to the gearbox. Don't loosen it too fast when loosening the clutch, otherwise it will turn off.

5. [Pacific Automobile Network] The correct starting method of the manual gear car: first make sure that the car is in idle gear, then step on the clutch with your left foot, hold the steering wheel with your left hand, and turn on the ignition switch with your right hand.Hold the shift lever with your right hand, change from idle gear to 1st gear, and then put down the handbrake with your right hand. Lift the clutch pedal slowly with your left foot (pay attention to be slow).

6. The correct starting method of the manual transmission car: be proficient in stepping on the clutch, practice more, and be stable.

car start steps

First, turn on the left turn signal, observe the road conditions, and ensure safety.Step on the brake, step on the clutch, start the car, hang the gear, release the brake, release the foot brake, slide the car, slowly lift the clutch, accelerate and upshift, and do it in one go. Start from the flat ground. First, turn on the left turn signal to observe the road conditions and ensure safety.

Hang to the first gear, and then relax the parking brake lever, that is, the handbrake. At the same time, observe the situation around the car and whether it has all the conditions to start.

Car start operation steps: first open the door, sit in the driving position, adjust the seat, and fasten the seat belt. Turn on the turn signal to remind the vehicles and passers-by behind.

Clutch fully stepped on: After starting the car, the left foot completely stepped on the clutch, which is prepared before the semi-clutch state. Hang the gear to the first gear: push it with the palm of your right hand and hang the gear of the shift lever into the first gear as the starting gear.

The correct method of starting a manual transmission automobile

1. The correct method of starting a manual transmission is as follows: step on the clutch pedal and hang the transmission lever into the first gear. Press the horn and relax the handbrake.

2. The correct way to start the manual transmission is as follows: 1 The clutch is completely stepped on. After starting the car, the left foot completely steps on the clutch. This is for the half-clutch state to hang the 2nd gear to the first gear with the palm of the right hand, and hang the gear lever gear into the 1st gear as the starting gear. 3 The left turn of the left turn signal Control the direction lamp.

3. The manual gear start is to step on the clutch, the second is to hang the gear, the third is to turn, the fourth to ring the horn, the fifth is to release the brake, release the clutch, and gently add oil to start. It should be noted that you must step on the clutch when you step on it.Bottom, otherwise it will cause great damage to the gearbox. Don't loosen it too fast when loosening the clutch, otherwise it will turn off.

4. The first step of driving is to start the vehicle. When starting the manual transmission model, pay attention to step on the accelerator with the right foot, slowly lift the clutch with the left foot, stabilize the steering wheel with the left hand, and hold the front end of the manual brake with the right hand; when you hear the throttle sound from high-pitched to calm, quickly lower the manual brake.

5. After starting the car, step on the clutch completely with your left foot to prepare for the semi-clutch state. Push with the palm of your right hand and hang the shift lever gear into the first gear as the starting gear. Press the turn signal control lever down with your left hand, and turn on the left turn signal to prompt the front and rear of the car.