HS code-driven CSR checks

List of catalogs of this article:

• 1, How to install the car foot pedal
• 2, What are the names of the three pedals on the foot of the car?
• 3、 Is the car's foot brake the front wheel or the rear wheel?
• 4, What are the three pedals at the foot of the car? What is it used for?

How to install the car foot pedal

1. Installation steps of the car foot pedal: open the door and wipe the installation part of the lower edge of the door frame; take out the car pedal and distinguish the front and back according to the length and arc Left and right; tear off the double-sided adhesive protective layer on the back of the car pedal and press it at the installation place; the car pedal is installed, and ensure that it will not be wet within a week.

2. Check the materials: make sure that the pedals, fixtures, brackets and bolts are intact. Put the foot pedal on the base, fix it in the center, and then fix it with a fixture. Install the bracket on the back of the foot pedal. After installation, fix the bolt to the bracket and install the fastener.

3. Variable speedHow to install the rear pedal of the car? Before installing the pedal, you must clearly distinguish between the drive side and the non-drive side, indicating that the non-drive side (left side) r Before installing the pedal, apply an appropriate amount of grease to the foot pedal thread can effectively eliminate threads and bends. First, install the drive side (right) pedal.

4. When installing the foot pedal in the car, you must loosen and remove a hexagonal screw at the position of the front wheel side skirt of the car. Then find the hole where the bracket can be installed directly in the chassis of the car. However, it should be noted that the original hole position of the car must be found, and manual punching must not occur.

5. Hello, it is generally recommended to go to the local car decoration shop or car repair shop to install it. If you have strong hands-on ability, you can consider installing it yourself. The bracket positioning refers to Figure 1, Figure 2 and Figure 3 for bracket positioning and preliminary installation.Note: The product does not need to remove the skirt, and there is no need to cut the skirt.

6. Fix it directly on the car ground with screws, and enough screw holes are reserved for users to install pedals.

What are the names of the three pedals on the foot of the car?

1. Clutch pedal, brake pedal, accelerator pedal. From left to right, the following are: on the far left is the clutch pedal, which is the patent of manual transmission. The weight, height and height of the clutch pedals of different models are different, which also adjusts different operating orientations.

2. The three pedals on the car are accelerator, brake and clutch! The accelerator pedal, also known as the acceleration pedal, is part of the automobile fuel supply system. By controlling its stepping volume, the engine intake is controlled, so as to control the engine speed.When stepping on the accelerator pedal, the force should be soft, so that you can step on it gently and lift it slowly.

3. The three foot pedals of a car are accelerator pedal, brake pedal and parking brake pedal. The following is an introduction to the three pedals of the car: The main function of the accelerator pedal is to control the opening of the engine throttle, thus controlling the power output of the engine.

4. The three pedals of a manual transmission car from left to right are clutch pedal, brake pedal and accelerator pedal. The left foot is responsible for stepping on the clutch, and the right foot is responsible for stepping on the brake and accelerator. Cars can be divided into manual transmission MT and automatic transmission AT. MT: There are three pedals from left to right, namely clutch, brake (brake) and accelerator.

5. The three pedals below the car are clutch pedals, brake pedals and accelerator pedals from left to right.The clutch pedal is the control device of the manual clutch car clutch assembly, which is the "human-machine" interaction part between the car and the driver.

Is the car's foot brake the front wheel or the rear wheel?

1. If the vehicle uses the handbrake, the brakes are generally the rear wheels. If the vehicle uses the foot brakes, the general brakes are the front and rear wheels. When the vehicle is running, the four wheels usually brake together, that is, the braking force between the front and rear wheels is slightly different. For foot brake models, the function of the foot brake is usually equivalent to four wheels.

2. The foot brake of the car controls the four wheels. 70% of the braking force is distributed by the front wheels, and only 30% is distributed by the rear wheels. The handbrake actually uses a steel wire rope to brake the rear wheel. Because of holding the handbrake, the rear wheel can't move forward, but the front wheel is still moving forward.At this time, the car will turn again.

3. The car foot brake is the front wheel: the principle of the handbrake is different. The car handbrake is generally transmitted by a steel cable, and the handbrake lever is connected to a steel cable. When we pull the lever, the steel cable pulls the two independent handbrake friction pads of the rear wheel, thus generating braking.

4. The foot brake of the car controls four wheels. The foot brake of the car controls 4 wheels, and the braking power is distributed by the load ratio. The front wheel distributes 70% of the braking force, and the rear wheel only distributes 30% of the braking power. The principle of handbrake is to use a steel wire rope to brake the rear wheel.

What are the three pedals at the foot of the car? What is it used for?

1. The three pedals of motor vehicles from left to right are: clutch pedal, brake pedal and accelerator pedal.These three pedals are limited to manual transmission cars, because automatic transmission cars do not need clutch pedals, so automatic transmission cars only have brake pedals and accelerator pedals. The names of these three pedals are different, and the functions they are responsible for are also different.

2. In the middle is the brake pedal, which is also the largest and thickest of the three pedals. Its function is to slow down or stop the car. The brake sensitivity and brake stroke of different models are different, which is related to the adjustment of the manufacturer. On the far right is the accelerator pedal, called the acceleration pedal, which is used to control the speed of the car.

3. The three pedals of a car from left to right are clutch pedals, brake pedals and accelerator pedals. The clutch pedal is used to control the clutch, the brake pedal is used to control the brake system, and the accelerator pedal can control the throttle opening.After stepping on the accelerator pedal, the throttle opening will become larger, so that the engine speed can be increased.