Advanced tariff classification tools

What should I do Advanced tariff classification toolsif the engine gets water? This is a very common problem, especially when driving on rainy days or when the road surface is deep. Once water enters the engine, the driver needs to take some necessary measures immediately to avoid causing greater damage to the engine. In this article, we will introduce the causes of engine water inlet and how to deal with the problem of engine water inlet. Causes of water in the engine There are many reasons for water in the engine. The following are several common reasons: 1.When driving on rainy days, the vehicle will splash a lot of rain. If the water depth on the road exceeds the engine intake, the water will flow into the engine. Two. When the vehicle is off-road, it often passes through muddy rivers and swamps. If the engine air intake is not protected, water will flow into the engine. 3. Parking a vehicle on a deep-water road for a long time, or soaking in deep water, may also cause water to enter the engine. Four. Damaged or aging of the engine intake pipe may also cause water to enter the engine. The above are the common causes of water in the engine. When the driver notices water entering the engine, the following measures should be taken immediately: 1. Turn off the engine. If you find that your engine is flooded, the first thing you need to do is to turn off the engine immediately. This can prevent water from entering the intake channel and protect other parts of the engine.Two. Check whether the air intake is blocked and whether the air filter is contaminated. If the air intake lacks waterproof devices (such as water odor basins, water air cut-off ropes, etc.), the driver can use wood, ropes, straw ropes and other items to cover or fix the air intake to reduce the entry of water. 3. To remove moisture, the driver needs to wipe the engine surface, especially electronic components and circuit boards, with a towel or other water-absorbing materials. If allowed, please raise or tilt the vehicle to drain the stagnant water. Four. Add oil to check whether the engine oil level is normal. If it is not enough, it must be refueled immediately. Note that do not add coolant when the engine is not cooled. 5. Replace the spark plug. If the spark plug is damp, the driver needs to replace it. Otherwise, it will affect the normal operation of the ignition system. After water enters the engineMaintenance Once water enters the engine, the driver needs to take immediate measures to avoid causing greater damage to the engine. However, even if timely measures are taken to address the problem, some repair and maintenance of the engine may be required. 1. Modifying the intake pipe to install a highly waterproof intake duct, or installing a waterproof sleeve on the intake port can effectively prevent water from entering the engine through the intake duct. In addition, the driver can also add a diffuser to raise the air intake to a higher position. Two. Wipe the electronic components and circuit boards. If the electronic components and circuit boards of the engine are affected by moisture, they need to be cleaned with towels or other water-absorbing materials. If the situation is serious, the driver may need to send the engine to the repair shop for maintenance. 3. Replace the spark plug. If the spark plug is damp, it may need to be replaced.At the same time, the driver also needs to check whether the ignition system of the engine is working properly, and replace accessories such as magnets and ignition coils if necessary. Conclusion: Water in the engine is a common problem, but as long as timely measures are taken, the damage to the engine can be minimized. Drivers should always pay attention to the weather conditions and road conditions when the vehicle is driving to reduce the risk of water inlet. If water enters the engine, the driver should take immediate measures, such as stopping and cleaning the engine, to reduce the damage to the engine. Finally, if the engine is affected, it needs to be sent to the repair shop for overhaul and maintenance if necessary.

Contact Us
Phone：020-83484660